Moon Zero Two is one of my favourite films. It was made by Hammer in 1969. Hammer usually made horror films, so this was a bit of a departure for them.
There's an excellent site by David Sissons which will tell you everything you need to know about the film.
Click here to go to Dave Sisson's Moon Zero Two site.
There are two types of vehicles seen in the film. The moon ferry (Moon Zero Two) and the moon bugs. The moon express is mentioned, but is only seen in one shot of the film (just to the right of MZ2 as it takes off).
I decided to make 3d printed models of the moon ferry and moon bug. I picked a size of approximately 580mm tall for the spaceship. At this size I could get all the detail I wanted, and it would fit in one of my display cabinets.
A full size moon bug was built for the film. A miniature was also used. Even though they had the same basic features, there were a lot of differences between the full size and miniature props. I couldn't decide which one I liked best, so I decided to make both versions, again 3d printed.
Here are some comparison renders of the two versions. (Full size prop on top)
You can email me at email@example.com